User`s guide

40
General Radio Features
Editing a Name in the List
1 Press and hold the PHON softkey to enter the phone ID list
programming.
The Phon indicator flashes and a high-pitched tone sounds.
2 Use the navigation keys,  or  to locate the list member you
want to change.
OR
Use the numbered keys to go immediately to the location of a
member in the list. For example, press 2 to go to the second
member in the list; press 1 and 0 to go to the tenth member in
the list, and so on.
3 Change the characters or numbers using any of the numeric
keys (0 through 9) and special function keys
(*, #).
Note: The maximum number of characters permitted in a text line
is 14. If you try to add too many characters, you will hear a
low-pitched tone.
To edit, do any or all of the following:
• To enter a character at the blinking cursor, refer to the table
on page 42.
Press the key of the desired character the number of times
shown in the table. For example, to enter the character C,
press the 2 key three times.
• To leave a space in the text, press the Mode up  rocker
switch to move the blinking cursor to the next character
position, and then enter the character.