Installation guide

AP6532 Series Access Point: Installation Guide
4
2 Hardware Installation
2.1 Installation Instructions
The AP6532 Access Point mounts either on a wall (with wide-shoulder screws) or on a suspended
ceiling T-bar. This unit is not designed for mounting on a desk.
To prepare for the installation, perform the following:
1. Match the model number on the purchase order with the model numbers in the packing list
and on the case of the device shipped.
2. Verify the contents of the box include the intended AP6532 Access Point and that the
included hardware matches the package contents on page 2.
3. Review site survey and network analysis reports to determine the location and mounting
position for the AP6532 Access Point.
Part Number Description
AP-6532-66030-US 802.11a/b/g/n dual radio integrated antenna configuration
United States model
AP-6532-66030-OUS 802.11a/b/g/n dual radio integrated antenna configuration
United States model for outdoor installation
AP-6532-66030-WW 802.11a/b/g/n dual radio integrated antenna configuration
World Wide model
AP-6532-66040-US 802.11a/b/g/n dual radio external antenna configuration
United States model
AP-6532-66040-OUS 802.11a/b/g/n dual radio external antenna configuration
United States model for outdoor installation
AP-6532-66040-WW 802.11a/b/g/n dual radio external antenna configuration
World Wide model
NOTE In the above part numbers, XX represents the 2-digit country code which
specifies which country the model is designed for. A country code of
“WW” represents a world wide model. The letter O preceding the 2-digit
country code specifies the model is designed for outdoor installation.