Installation guide

22 AP 7161 Access Point Installation Guide
Ancillary hardware to attach the extension arm to the mounting hardware kit sections is included in the extension arm kit.
Pole Mounted Installations
The mounting hardware kit and extension arm can be used in various combinations to properly install the AP 7161 on a pole. For
poles of up to 3 inches in diameter, attach the pole mount section of the mounting hardware kit at the desired position on the
pole using a 1/2 inch U-bolt and nuts. For poles greater than 3 inches in diameter, attach the pole mount bracket section using
band clamps.
The U-bolt and band clamps are not included in the mounting hardware kit.
Description Quantity
1/2 inch hex head nut 2
1/2 inch x 3/4 inch hex head bolt 2
NOTE Use of the extension arm is recommended for installations on poles greater than 3 inches in
diameter.
CAUTION Always mount the AP 7161 with the black gore vent facing down.
!