Installation guide

AP 7161 Access Point Installation Guide 11
Verify that the deployment environment has a continuous temperature range compatible with the operating temperature
range of the device.
Warnings
Read all installation instructions and site survey reports, and verify correct equipment installation before connecting the
access point to its power source.
Remove jewelry and watches before installing this equipment.
Verify that the unit is grounded before connecting it to the power source.
Verify that any device connected to this unit is properly wired and grounded.
Connect all power cords to a properly wired and grounded electrical circuit. Verify that the electrical circuits have appropriate
overload protection.
Attach only approved power cords to the device.
Verify that the power connector and socket are accessible at all times during the operation of the equipment.
Do not hold any component containing a radio such that it is very close to or touching any exposed parts of the body,
especially the face or eyes, while transmitting.
Do not work with power circuits in dimly lit spaces.
Do not install this equipment or work with its power circuits during thunderstorms or other weather conditions that could
cause a power surge.
Verify there is adequate ventilation around the device, and that ambient temperatures meet equipment operation
specifications.
Avoid contact with overhead power lines.
Take precautions to avoid injury from falling tools and equipment. Crews should wear hard hats in and around the installation
work site.
Be aware of vehicular traffic in and around the installation work site.
Do not operate a portable transmitter near unshielded blasting caps or in an environment where explosives are present
unless the transmitter is especially certified for such use.
Refer to your site survey, network analysis reports, and the AP 7161 System Planner to determine specific requirements for
each deployment.
Assign installation responsibility to the appropriate personnel.
Identify and document where all installed components are located.
Identify and prepare Ethernet and console port connections.
Verify that cable lengths are within the maximum allowable distances for optimal signal transmission.
CAUTION The maximum length allowed for PoE cables is 100 meters.
!