Installation guide

10 AP 7161 Access Point Installation Guide
Package Contents
Carefully remove all protective packing material from around the AP 7161 access point and save the container for later storage
and shipping.
Refer to AP 7161 Hardware on page 8 when verifying receipt of all hardware a accessory items which should be included in your
order.
Verify that you received the equipment listed below:
• AP 7161 access point
• Weatherproof RJ45 plug kit
• AP 7161 Access Point Installation Guide
Verify that you have received all accessories that were purchased:
• Mounting brackets
• PoE unit
• Lightning protection unit
• Antennas
The following items are not included with the AP 7161:
• Cat5E cable to connect power source
• Band clamps, lag bolts or U-bolts for some mounting scenarios
• Grounding wire
Inspect the equipment for damage. If you are missing any equipment or if you find any damaged equipment, contact Motorola
Solutions Support immediately.
Hardware Installation Guidelines
Precautions
Before installing an AP 7161 model access point verify the following:
• Become familiar with all grounding requirements (see Installing an AP 7161 on page 20)
• The grounding cable for an AP 7161 must be a #10 gauge wire cross section. The cable can be attached to the unit using
one of the three recommended methods:
• Loosen the grounding screw, insert the grounding cable into the hole below it, and tighten the screw.
• Loosen the grounding screw, wind the grounding cable around it, and tighten the screw.
• Attach a ring lug to the grounding cable and secure it to the unit using the grounding screw.
CAUTION All device wiring must comply with the National Electric Code (NEC) or
regulations and procedures defined by the regulatory bodies of the country or
region where the devices are being deployed. All local building and structure
codes must be observed.
WARNING! Strictly observe the following Safety Warnings and Precautions when installing
an AP 7161 access point.
!