Specifications

Configuring Access Point Security
6-21
4. Click Apply to save any changes to the Advanced Subnet Access screen. Navigating away
from the screen without clicking Apply results in all changes to the screens being lost.
5. Click Undo Changes (if necessary) to undo any changes made. Undo Changes reverts the
settings displayed on the Advanced Subnet Access screen to the last saved configuration.
6. Click Logout to securely exit the Access Point applet. A prompt displays confirming the
logout before the applet is closed.
Move Down Clicking the Move Down button moves the selected rule down by
one row in the table. The index numbers for the affected rows
adjust to reflect the new order.
Index The index number determines the order firewall rules are executed.
Rules are executed from the lowest number to the highest number.
Rule Id Rule Id is read-only and automatically set when Apply button is
clicked. For Inbound policies Rule Id starts from 1245 and for
Outbound policies Rule Id starts from 10.
Source IP The Source IP range defines the origin address or address range
for the firewall rule. To configure the Source IP range, click on the
field. A new window displays for entering the IP address and range.
Destination IP The Destination IP range determines the target address or
address range for the firewall rule. To configure the Destination IP
range, click on the field. A new window displays for entering the IP
address and range.
Transport Select a protocol from the drop-down list. For a detailed description
of the protocols available, see Available Protocols on page 6-17.
Src. Ports (Source
Ports)
The source port range determines which ports the firewall rule
applies to on the source IP address. Click on the field to configure
the source port range. A new window displays to enter the starting
and ending port ranges. For rules where only a single port is
necessary, enter the same port in the start and end port fields.
Dst. Ports (Destination
Ports
The destination port range determines which ports the firewall rule
applies to on the destination IP address. Click on the field to
configure the destination port range. A new window displays to
enter the starting and ending ports in the range. For rules where
only a single port is necessary, enter the same port in the start and
end port fields.