Installation guide

Basic Configuration

4. Select the Auto (IKE) Key Exchange checkbox and the IKE Settings button.

IKE provides an automatic means of negotiation and authentication for communication

between two or more entities.

5. Configure all the parameters within the IKE Settings screen.The IKE Authentication

Passphrase must be shared by the external NTP, syslog or Radius resource.

6. From back within the VPN screen, select the Auto (IKE) Key Exchange checkbox and the

Auto Key Settings button.

Use the Auto Key Settings screen to specify the type of encryption and authentication used

with the tunnel.

7. Configure all the parameters within the Auto Key Settings screen.

For additional information on configuring either IKE Settings or Auto Key Settings, refer to

the AP-7131N-FGR Access Point Product Reference Guide available at

https://support.symbol.com/support/product/FIPS_and_CC_Compliant_Products.html

8. Click Apply to save the configuration of the new tunnel.

External NTP, syslog and Radius resources are now reachable from the access point’s secure

VPN tunnel. However, you must supply the access point with the IP address of the NTP,

syslog or Radius server for the access point to connect to those external resources. For

information on configuring external NTP, syslog and Radius server support, refer to the

AP-7131N-FGR Access Point Product Reference Guide available at

https://support.symbol.com/support/product/FIPS_and_CC_Compliant_Products.html

3.4.3 Excluding MUs from Association

Optionally, use the access point Access Control List ACL to specify which MUs can or cannot gain

access to an access point managed WLAN. By default, all mobile units can gain access. For specific

information on configuring (restricting) MU access, refer to the AP-7131N-FGR Access Point Product

Reference Guide. The guide is available on the Motorola Web site, at

https://support.symbol.com/support/product/FIPS_and_CC_Compliant_Products.html

Remote Subnet Mask Enter the subnet mask for the tunnel’s remote network for the

tunnel. The remote subnet mask is the subnet setting for the

remote network the tunnel connects to.

Remote Gateway Enter a numerical (non-DNS) remote gateway IP address for the

tunnel. The remote gateway IP address is the gateway address on

the remote network the VPN tunnel connects to.