Installation guide

AP-7131N-FGR Access Point: Installation Guide
34
1. Select Network Configuration -> WAN -> VPN from the access point menu tree.
2. Select the Add button from within the VPN Tunnels field to define the attributes of a new
tunnel to provide secure access to the access point’s external NTP, syslog or Radius
resources.
3. Refer to the VPN Tunnel Config field and define the following attributes for the VPN
tunnel:
Tunnel Name Enter a name to define the VPN tunnel. The tunnel name is used to
uniquely identify each tunnel.
Interface name Use the drop-down menu to specify the LAN1, LAN2 or WAN
connection used for routing VPN traffic. Remember, only one LAN
connection can be active on the access point Ethernet port at a
time.
Local WAN IP Enter the WAN’s numerical (non-DNS) IP address in order for the
tunnel to pass traffic to a remote network.
Remote Subnet Specify the numerical (non-DNS) IP address for the Remote Subnet.