Installation guide

AP-7131N-FGR Access Point: Installation Guide

correct country is central to legally operating the access point. Each country has its own

regulatory restrictions concerning electromagnetic emissions and the maximum RF

signal strength that can be transmitted. To ensure compliance with national and local

laws, set the country accurately.

c. Optionally enter the IP address of the server used to provide system time to the access

point within the Time Server field. Once the IP address is entered, the access point’s

Network Time Protocol (NTP) functionality is engaged automatically. With the

AP-7131N-FGR, a VPN tunnel is established using the NTP server.

d. Define a primary and alternate WIPS server IP Address for WIPS Server 1 and 2. These

are the addresses of the primary and secondary WIPS console server. WIPS support

requires a Motorola AirDefense WIPS Server on the network. WIPS functionality is not

provided by the access point alone. The access point works in conjunction with the

dedicated WIPS server(s).

4. Refer to the new Radio Configuration field to define how WLAN and WIPS are supported

by the access point’s radio(s).

A dual radio AP-7131N-FGR access point displays 7 configuration options. Refer to the

following table for the options available to AP-7131N-FGR models.

NOTE The System Name and Country are also configurable within the System

Settings screen. Refer to the AP-7131 Series Product Reference Guide to

optionally set a system location and admin email address for the access

point or to change other default settings.

Radio Button AP-7131N-FGR Dual Radio SKU

2.4 GHz WLAN,

& Sensor

Radio1 WLAN,

Radio 2 WIPS

5.0 GHz WLAN

& Sensor

Radio 1 WIPS,

Radio 2 WLAN

2.4 GHz WLAN &

5.0 GHz WLAN only -

no Sensor

Radio 1 WLAN,

Radio 2 WLAN

Sensor only Spectrum Analysis mode

(no WLAN)

Radio 1 WIPS,

Radio 2 WIPS

2.4 GHz WLAN -

no Sensor

Radio1 WLAN,

Radio 2 Disabled