Installation guide

AP-7131N-FGR Access Point: Installation Guide
24
3.3 Resetting the Access Point’s Password
The access point has a means of restoring its password to its default value. Doing so also reverts the
access point’s security, radio and power management configuration to their default settings. Only an
installation professional should reset the access point’s password and promptly define a new
restrictive password.
To contact Motorola Support in the event of a password reset requirement, go to
http://www.symbol.com/contactsupport
.
3.4 Configuring “Basic” Device Settings
Configure a set of minimum required device settings within the Quick Setup screen. The values
(LAN, WAN etc.) can often be defined in other locations within the menu tree. When you change the
settings in the Quick Setup screen, the values also change within the screen where these parameters
also exist. Additionally, if the values are updated in these other screens, the values initially set within
the Quick Setup screen will be updated.
To define a basic access point configuration:
1. Select System Configuration -> Quick Setup from the menu tree, if the Quick Setup
screen is not already displayed.
CAUTION Only a qualified installation professional should set or restore the
access point’s radio and power management configuration in the
event of a password reset.
NOTE Beginning with the 4.0 release of the access point firmware, a new
scheme for radio configuration and WIPS server management has been
implemented within the Quick Setup GUI applet. These radio buttons
define how WLAN and sensor functionality are supported amongst the
radios available to the access point. The options available depend on the
SKU supported (and are described within this section).
!