Installation guide

AP-7131N-FGR Access Point: Installation Guide

3.2 Configuring the Access Point

For the basic setup described in this guide, the Java-based Web UI will be used to configure the

access point. The GE1/POE port’s default setting is static (with a default IP address of 192.168.0.1).

For this example, the access point’s WAN interface will be used to connect to the access point. The

default WAN IP address is 10.1.1.1. For optimal viewing of the Web UI, the screen resolution should

be set to 1024 x 768 pixels or greater.

Remember, Internet Explorer and Mozilla Firefox require unique settings be defined in order for the

browser to access the AP-7131N-FGR GUI applet. For instructions on configuring these browser

settings, see “

Configuring Your Browser for AP-7131N-FGR Support” on page 21.

1. Start a browser and enter the following IP address in the address field:

https://10.1.1.1

The login screen displays.

NOTE For advanced configuration options beyond the scope of this guide, refer

to the AP-7131N-FGR Access Point Product Reference Guide. The guide is

available on the Motorola Web site, at

https://support.symbol.com/support/product/

FIPS_and_CC_Compliant_Products.html.

NOTE For optimum compatibility, use Sun Microsystems’ JRE 1.6 or higher

(available from Sun’s Website), and be sure to disable Microsoft’s Java

Virtual Machine if installed.

NOTE The computer being used should be configured to use the same

IP address and subnet mask as the access point.