Installation guide

AP-7131N-FGR Access Point: Installation Guide
20
2.6.2 Rear AP-7131N-FGR LED
The LED on the rear (bottom) of the access point is optionally viewed using a single (customer
installed) extended light pipe, adjusted as required to suit above the ceiling installations. The LED
light pipe has the following color display and functionality
3 Basic Configuration
3.1 Configuring Your Browser for AP-7131N-FGR Support
An AP-7131N-FGR model access point is compliant with the FIPS140-2 standard. The AP-7131N-FGR
is only accessible using browsers that support the TLS 1.0 protocol. The AP-7131N-FGR is not
accessible by browsers supporting the SSL 2.0 or SSL 3.0 protocols. Additionally, ensure JRE (version
1.6 or above) is installed on the computer accessing the AP-7131N-FGR GUI applet. The following
sections describe how to change your browser settings using either Internet Explorer or Mozilla
Firefox in order to correctly launch and display the AP-7131N-FGR GUI applet. Without these browser
modifications, you will not be able to access the AP-7131N-FGR GUI applet.
3.1.1 Accessing the AP-7131N-FGR Using Internet Explorer
To define the browser settings needed to access the AP-7131N-FGR using Windows Internet Explorer:
1. Open the Internet Explorer browser and open the Tools > Internet Options menu.
2. Select the Advanced tab.
3. Scroll down to the bottom of the Advanced tab and ensure the Use TLS 1.0 option is
selected. Remember, the AP-7131N-FGR does not support SSL 2.0 or SSL 3.0.
LED 7
Blinking Red (160 msec) indicates a failure condition.
Solid Red defines the diagnostic mode.
White defines normal operation.
CAUTION With both the Internet Explorer and Mozilla Firefox browser
configurations, screens may display stating Website certificates
cannot be validated or have been certified by an unknown authority.
Do not exit the browser configuration, as these messages will occur
with only the initial AP-7131N-FGR browser configuration.
!