Specifications

System Configuration
4-5
4. Use the Restart access point field to restart the AP (if necessary).
5. Click Apply to save any changes to the System Settings screen. Navigating away from the
screen without clicking the Apply button results in all changes to the screen being lost.
CAUTION Restoring the access point’s configuration back to default settings
changes the administrative password back to “motorola.” If restoring
the configuration back to default settings, be sure you change the
administrative password accordingly.
Restore Default
Configuration
Select the Restore Default Configuration button to reset the
AP’s configuration to factory default settings. If selected, a
message displays warning the user the current configuration will
be lost if the default configuration is restored. Before using this
feature, Motorola recommends using the Config Import/Export
screen to export the current configuration for safekeeping, see
Importing/Exporting Configurations on page 4-46.
Restore Partial
Default Configuration
Select the Restore Partial Default Configuration button to
restore a default configuration with the exception of the current
LAN, WAN, SNMP settings and IP address used to launch the
browser. If selected, a message displays warning the user all
current configuration settings will be lost with the exception of
WAN and SNMP settings. Before using this feature, Motorola
recommends using the Config Import/Export screen to export the
current configuration for safekeeping, see Importing/Exporting
Configurations on page 4-46.
Restart AP-7131 Click the Restart access point button to reboot the AP. Restarting
the access point resets all data collection values to zero. Motorola
does not recommend restarting the AP during significant system
uptime or data collection activities.
CAUTION After a reboot, static route entries disappear from the AP Route Table
if a LAN Interface is set to DHCP Client. The entries can be retrieved
(once the reboot is done) by performing an Apply operation from the
WEB UI or a save operation from the CLI.
!
!