Specifications

AP-7131 Access Point Product Reference Guide
4-38
5. Configure the System Traps field to generate traps when the access point re-initializes
during transmission, saves its configuration file. When a trap is enabled, a trap is sent every
5 seconds until the condition no longer exists.
6. Click Apply to save any changes to the SNMP Traps screen. Navigating away from the
screen without clicking the Apply button results in all changes to the screen being lost.
Physical port status
change
Generates a trap whenever the status changes on the access point.
The physical port status changes when a link is lost between the
access point and a connected device.
DynDNS Update Generates a trap whenever domain name information is updated as
a result of the IP address associated with that domain being
modified.
Denial of service
(DOS) attempts
Generates a trap whenever a Denial of Service (DOS) attack is
detected by the access point firewall. A new trap is sent at the
specified interval until the attack has stopped.
Send trap every Defines the interval in seconds the access point uses to generate a
trap until the Denial of Service attack is stopped. Default is 10
seconds.
System Cold Start Generates a trap when the access point re-initializes while
transmitting, possibly altering the SNMP agent's configuration or
protocol entity implementation.
Configuration
Changes
Generates a trap whenever changes to the access point’s
configuration file are saved.
Rogue AP Detection Generates a trap if a Rogue AP is detected by the access point.
AP Radar Detection Generates a trap if an AP is detected using a form of radar
detection.
WPA Counter
Measure
Generates a trap if an attack is detected against the WPA Key
Exchange Mechanism.
MU Hotspot Status Generates a trap when a change to the status of MU hotspot
member is detected.
VLAN Generates a trap when a change to a VLAN state is detected.
LAN Monitor Generates a trap when a change to the LAN monitoring state is
detected.