User manual

SM User Manual January 2004
Software Release 4.1
Figure 36: Configuration screen for 2.4-GHz SM
The Configuration web page contains all of the configurable parameters that define how the
module operates. The first line of information on the Configuration screen echoes the Device Type
from the Status web page.
8.2.1 Configuration Parameters
As shown in Figure 35, the Configuration page provides the following parameters:
802.3 Link Enable/Disable
The operator specifies whether to not allow the SM to send and receive data through the Ethernet
port even when the RF link to the AP is active. This field toggles on or off the Browser-based
Disabling of Subscriber Module Ethernet Interface feature in Release 3.2 and later releases. The
operator can alternatively control this feature from the AP.
When enabled, this feature
• disallows the SM user to access the link, as in the case where the user account is
delinquent.
• allows the operator to partition the network for troubleshooting or another analytical or
operation function.
Issue 5 Page 86 of 119