User manual

SM User Manual January 2004
Software Release 4.1
(4) Listen to the alignment tone for
• pitch, which indicates greater RSSI by higher pitch.
• volume, which indicates less jitter by higher volume.
• cadence, which indicates registration to the AP by a tone interruption of 0.155
seconds of quiet in each 2-second interval.
In Adobe Reader
®
6.0 or later release, to hear an example of the alignment tone
as the SM aligns and registers, click on the picture in Figure 32.
Figure 32: Audible Alignment Tone kit and example tone
(5) Move the module slightly until you hear the highest pitch and highest volume.
(6) Continue to move the module slightly until you hear the tone interruptions, if
possible.
12. On the computer, in the RSSI Only Mode field, click Enabled.
13. Click Enable Aiming Mode.
14. Simultaneously, begin to
• move the module slightly in the vertical plane.
• on the computer, click Enable Aiming Mode frequently to refresh the page as the
module moves (or select the auto-refresh option for this web page).
• monitor the screen for a simultaneous RSSI level of greater than 700, jitter value
between 0 and 4 in Release 4.0 and later releases or between 5 and 9 in any
earlier release, and efficiencies greater than 90% for both the uplink and the
downlink.
15. When the RSSI level is greater than 700, stop the movement of the module and click
Disable in the RSSI Only Mode field.
16. Access the Status page.
Issue 5 Page 79 of 119