User manual

SM User Manual January 2004

Software Release 4.1

For a description of interactions between settings of these types of passwords, see

Display-Only Access on Page 88 and Full Access on Page 88.

NOTE: If the operator forgets either the password or the IP address for the module, a

Canopy system override plug can be used to regain access. For details, see

Overriding IP Address and Password Setting on Page 73.

2. Populate the Site Name, Site Location, and Site Contact fields. This is for only

information purposes. See

• Site Name on Page 91.

• Site Contact on Page 91.

• Site Location on Page 91.

7.4 INSTALLING THE SM

NOTE: When power is applied to a Canopy module or the unit is reset on the web-based interface,

the module requires approximately 25 seconds to boot. During this interval, self-tests and other

diagnostics are being performed.

To install the Canopy SM, perform the following steps:

Procedure 14: Installing the SM

1. Remove the base cover of the SM. (See Figure 29 on Page 69.)

2. In the powered down state, attach the cables to the SM.

(See Cabling the SM on Page 70 and Figure 30 on Page 77.)

Computer

outside wall

Ethernet cable

300SS

ground

system

Ethernet cable

10 AWG

CU wire

to NIC

24 VDC to

Canopy

wall adapter

Figure 30: SM and computer wiring

3. Choose the best mounting location for your particular application.

4. Optionally, attach the SM to the arm of the Canopy Passive Reflector dish assembly as

shown in Figure 31.

Issue 5 Page 77 of 119