User manual

SM User Manual January 2004

Software Release 4.1

7 SM MODULE INSTALLATION

The following steps are required to install a Canopy SM:

1. Unpacking the Canopy Products. See Page 69.

2. Cabling the SM. See Page 70.

3. Configuring the SM. See Page 75.

4. Installing the SM. See Page 77.

5. Verifying System Performance. See Page 80.

7.1 UNPACKING THE CANOPY PRODUCTS

Upon receipt, carefully inspect all shipping boxes for signs of damage. If you find damage,

immediately notify the transporatation company.

Unpack the equipment, making sure that all of the components ordered have arrived. Saving all the

packing materials is recommended. These can be used to transport the equipment to and from

installation sites.

7.1.1 Component Layout

The simple design of the Canopy SM allows for easy deployment. As shown Figure 29, the base

cover of the module snaps off when a lever on the back of the base cover is depressed. This

exposes the Ethernet and GPS sync connectors and diagnostic LEDs.

Ethernet

Cable

Cano

RJ45

Connector

Connection

LEDs

Base Cover

RJ11

Connector

Ethernet

Cable

Base Cover

Release

Lever

Base Cover

Figure 29: Canopy SM base cover, attached and detached

Issue 5 Page 69 of 119