User manual

SM User Manual January 2004
Software Release 4.1
Undo Saved Changes
When the operator clicks this button, any changes that have been made but were not committed by
a reboot of the module are undone.
Set to Factory Defaults
When the operator clicks this button, all configurable parameters are reset to the factory settings.
Reboot
When the operator clicks this button, the module reboots. When the operator has changed
parameters in the NAT Configuration page, the system highlights the Reboot button as a reminder
that a reboot (in addition to a save operation) is required to implement the changes.
8.5 EVENT LOG PAGE
This page may contain information that can be useful under the guidance of Canopy technical
support. For this reason, the operator should not clear the contents of this page before contacting
technical support.
An example of the Event Log screen is displayed in Figure 49.
Figure 49: Event Log screen
8.5.1 Event Log Operator Option
The Event Log page provides only one button for the operator:
Clear Event Log
When the operator clicks this button, all of the Event Log page data is cleared.
Issue 5 Page 106 of 119