Radio User Manual

English

SCAN

DELETE A NUISANCE CHANNEL

Note: Your dealer/programmer must preprogram a

button to access this feature.

If a channel continually generates unwanted calls or

noise (a “nuisance” channel), you can temporarily

remove it from the scan list:

Restore Channels to the Scan List

EDIT A SCAN LIST

Your radio can support up to 16 Scan lists. Each

Scan list can contain up to 16 channels. The same

channel can be included in several Scan lists, and

the same Scan list can be assigned to several

channels. Scan lists are assigned per channel, by

your dealer/programmer. When you edit a Scan list,

you can either add, delete, or prioritize channels.

Note: Your radio cannot receive calls while you are

editing a Scan list.

1 While the radio is on the Nuisance Channel,

press the preprogrammed Nuisance

Channel Delete button until you hear a tone.

2 Release the Nuisance Channel Delete

button. The nuisance channel is deleted.

Note: You cannot temporarily delete the

channel that has been pre-prgrammed

by your dealer/programmer as your

designated scan channel, a priority

channel, or the last remaining channel

in the scan list.

1 Power off the radio. Once the radio is powered

on again, the deleted nuisance channels are

restored to the scan list.

–

1 Press the preprogrammed Scan button to stop

the scan.

2 Press the preprogrammed Scan button again

to start scanning again. The Deleted Nuisance

Channels are restored to the scan list.

–

1 Select a channel that has not been

preprogrammed for scan by your dealer /

programmer to stop Scan. Once you return to

the original channel, the deleted nuisance

channels are restored to the scan list.