User guide

National and Regional Regulatory Notices Regulatory and Legal Notices

586

pmp-0229 (Mar 2013)

Industry Canada (IC) Notification

This device complies with RSS-210 of Industry Canada. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) This device must accept

any interference received, including interference that may cause undesired operation.

Users should be cautioned to take note that in Canada high power radars are allocated as primary

users (meaning they have priority) of 5250 – 5350 MHz and 5650 – 5850 MHz and these radars

could cause interference and/or damage to license-exempt local area networks (LELAN).

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to RSS-210 of Industry Canada. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses, and can radiate radio-frequency energy and, if not installed and used in accordance with

these instructions, may cause harmful interference to radio communications. If this equipment

does cause harmful interference to radio or television reception, which can be determined by

turning the equipment on and off, the user is encouraged to correct the interference by one or more

of the following measures:

• Increase the separation between the affected equipment and the unit;

• Connect the affected equipment to a power outlet on a different circuit from that which the

receiver is connected to;

• Consult the dealer and/or experienced radio/TV technician for help.

To reduce potential radio interference to other users, the antenna type and its gain should be

chosen so its Equivalent Isotropic Radiated Power (EIRP) is not more than that permitted for

successful communication.

Industry Canada Certification Numbers and the specific configurations covered are listed in

Table

This device has been designed to operate with the antennas listed in Table 83 and having a

maximum gain as shown in Table 83

. Antennas not included or having a gain greater than as

shown in Table 83 are strictly prohibited from use with this device. Required antenna impedance

is 50 ohms.