User guide
508
pmp-0229 (Mar 2013)
Viewing the Scheduler Tab (All) Using Informational Tabs in the GUI
Event Message Meaning
Transmit Broadcast Data
Count
The total amount of broadcast packets transmitted from the radio
Receive Unicast Data Count The total amount of unicast packets received by the radio
Receive Broadcast Data
Count
The total amount of broadcast packets received by the radio
Transmit Control Count The amount of radio control type messages transmitted
(registration requests and grants, power adjust, etc.).
Receive Control Count The amount of radio control type messages received (registration
requests and grants, power adjust, etc.).
In Sync Count Number of times the radio has acquired sync. In the case of an
AP generating sync this is when generated sync has been locked,
or if GPS synchronization is used it is number of times GPS sync
acquired. For the SM, it is the number of times the SM
successfully obtained sync with an AP.
Out of Sync Count Number of times the radio lost same sync lock.
Overrun Count Number of times FPGA frame has overrun its TX Frame
Underrun Count Number of times FPGAs TX Frame aborted prematurely.
Receive Corrupt Data Count Number of times a corrupt fragment has been received at the
FPGA.
Receive Bad Broadcast
Control Count
Number of times the radio has received an invalid control
message via broadcast (SM only).
Rcv LT Start Number of Link Test Start messages received. A remote radio
has requested that this radio start a link test to it.
Rcv LT Start HS Number of Link Test Start Handshake messages received. This
radio requested that a remote radio start a link test and the remote
radio has sent a handshake back acknowledging the start.
Rcv LT Result This radio received Link Test results from the remote radio under
test. When this radio initiates a link test, the remote radio will
send its results to this radio for display.
Xmt LT Result This radio transmitted its link test results to the remote radio
under test. When the remote radio initiates a link test, this radio
must send its results to the remote radio for display there.