User guide

502
pmp-0229 (Mar 2013)
Viewing Session Status (AP, BHM) Using Informational Tabs in the GUI
Chapter 27: Using Informational Tabs in
the GUI
Viewing General Status (All)
See
• General Status Tab of the AP on Page 212.
• General Status Tab of the SM on Page 207.
• General Status Tab of the BHM on Page 229.
• Beginning the Test of Point-to-Point Links on Page 223.
Viewing Session Status (AP, BHM)
The Session Status tab in the Home page provides information about each SM that has registered
to the AP. This information is useful for managing and troubleshooting a system. This tab also
includes the current active values on each SM for MIR, CIR, and VLAN, as well as the source of
these values, representing the SM itself, BAM, or the AP and cap.
• (SM) – QoS/VLAN parameters are derived from the SM’s settings
• (APCAP) – QoS/VLAN parameters are derived from the AP’s settings, including any keyed
capping (for radios capped at 4 Mbps, 10 Mbps, or 20 Mbps)
• (D) – QoS/VLAN parameters are retrieved from the device, due to failed retrieval from the
AAA or WM server.
• (AAA) – QoS/VLAN parameters are retrieved from the RADIUS server
• (BAM) – QoS/VLAN parameters are retrieved from a WM BAM server
An example of the Session Status tab is displayed in Figure 158.