User guide

Canopy System User Guide Configuring Management IP by DHCP
pmp-0229 (Mar 2013)
439
• no attempt to access the SM management interface (by http, SNMP, telnet, ftp, or tftp)
through Ethernet can succeed.
• any attempt to access the SM management interface over the air (by IP address, presuming
that LAN1 Network Interface Configuration, Network Accessibility is set to Public, or by
link from the Session Status or Remote Subscribers tab in the AP) is unaffected.
Allowing Management from Only Specified IP
Addresses
The Security tab of the Configuration web page in the AP, SM, and BH includes the IP Access
Control parameter. You can specify one, two, or three IP addresses that should be allowed to
access the management interface (by http, SNMP, telnet, ftp, or tftp).
If you select
• IP Access Filtering Disabled, then management access is allowed from any IP address, even
if the Allowed Source IP 1 to 3 parameters are populated.
• IP Access Filtering Enabled, and specify at least one address in the Allowed Source IP 1 to
3 parameter, then management access is limited to the specified address(es). If you intend to
use Prizm to manage the element, then you must ensure that the IP address of the Prizm server
is listed here.
Configuring Management IP by DHCP
The IP tab in the Configuration web page of every radio contains a LAN1 Network Interface
Configuration, DHCP State parameter that, if enabled, causes the IP configuration (IP address,
subnet mask, and gateway IP address) to be obtained through DHCP instead of the values of those
individual parameters. The setting of this DHCP state parameter is also viewable, but is not
settable, in the Network Interface tab of the Home page.
In the SM, this parameter is settable
• in the NAT tab of the Configuration web page, but only if NAT is enabled.
• in the IP tab of the Configuration web page, but only if the Network Accessibility parameter
in the IP tab is set to Public.