User guide

Installing a BH Timing Master Installing Components
410
pmp-0229 (Mar 2013)
Figure 144: Mounting assembly, exploded view
Installing a BH Timing Master
Installing a PTP 100 Series BHM
To install a PTP 100 Series (FSK) BHM, perform the following steps.
Procedure 26: Installing the FSK BHM
1. Access the General tab of the Configuration page in the BHM.
2. If this is a 20-Mbps BH, set the 2X Rate parameter to Disabled (temporarily for easier
course aiming).
3. Click the Save Changes button.
4. Click the Reboot button.
5. After the reboot is completed, remove power from the BHM.
6. Choose the best mounting location for your particular application.
7. Attach the BHM to the arm of the Passive Reflector dish assembly as shown in Figure
145 or snap a LENS into place on the BHM.