User guide

Canopy System User Guide Configuring a BH Timing Slave for the
Destination
pmp-0229 (Mar 2013)
375
Default Port VID
This is the value of the parameter of the same name, configured above.
Management VID
In a backhaul module, this value will always be 1. This facilitates deployment of devices that have
VLAN enabled with those that do not.
QinQ
This is set to Enabled if VLAN Port Type is set to QinQ, and is set to Disabled if VLAN Port
Type is set to Q.
QinQ EthType
This is the value of the QinQ EtherType configured in the AP.
Type
In a backhaul module, this value will always be Permanent, reflective of the fact that the backhaul
is not capable of deleting any VID membership, regardless of whether it was learned or set.
Age
In a backhaul module, this value will always be 0, reflective of the fact that the backhaul is not
capable of deleting any VID membership, regardless of whether it was learned or set.
The VLAN tab also provides the following buttons.
Save Changes
When you click this button, any changes that you made on the Configuration page are recorded in
flash memory. However, these changes do not apply until the next reboot of the module.
Reboot
When you click this button
1. the module reboots.
2. any changes that you saved by a click of the Save Changes button are
implemented.
Diffserv Tab of the BHS
An example of the Diffserv tab in a BHS is displayed in Figure 118.