User guide

Canopy System User Guide Configuring a BH Timing Slave for the
Destination
pmp-0229 (Mar 2013)
373
Figure 117: VLAN tab of BHS, example
In the VLAN tab of the BHM, you may set the following parameters.
VLAN
Set the VLAN feature to Enabled or Disabled. When the feature is disabled, the text box for the
following parameter is inactive. When the Management VID is enabled by this parameter, the
module is manageable through only packets that are tagged with the VID configured in that
parameter. These parameters have no bearing on tagging in non-management traffic.
By default, VLAN is Enabled in backhaul modules. With this feature enabled, the backhaul
becomes a permanent member of any VLAN VID that it reads in packets that it receives. When
the backhaul reboots, it loses these memberships, but begins again to freely adopt memberships in
the VIDs that will be permanent until the next reboot.