User guide

Configuring a BH Timing Slave for the
Destination
Configuring for the Destination
372
pmp-0229 (Mar 2013)
Allowed Source IP 1 to 3
If you selected IP Access Filtering Enabled for the IP Access Control parameter, then you must
populate at least one of the three Allowed Source IP parameters or have no access permitted to
the BHS from any IP address. You may populate as many as all three.
If you selected IP Access Filtering Disabled for the IP Access Control parameter, then no entries
in this parameter are read, and access from all IP addresses is permitted.
The Security tab of the BHS also provides the following buttons.
Save Changes
When you click this button, any changes that you made on this tab are recorded in flash memory.
However, these changes do not apply until the next reboot of the module.
Reboot
When you click this button
1. the module reboots.
2. any changes that you saved by a click of the Save Changes button are
implemented.
VLAN Tab of the BHS
An example of the VLAN tab in a BHS is displayed in Figure 117.