User guide

Canopy System User Guide Configuring a BH Timing Slave for the
Destination
pmp-0229 (Mar 2013)
371
Figure 116: Security tab of BHS, example
In the Security tab of the BHS, you may set the following parameters.
Authentication Key
Only if the BHM to which this BHS will register requires authentication, specify the key that the
BHS should use when authenticating. For alpha characters in this hex key, use only upper case.
NOTE:
Cambium recommends that you enter 32 characters to achieve the maximal
security from this feature.
Web, Telnet, FTP Session Timeout
Enter the expiry in seconds for remote management sessions via HTTP, telnet, or ftp access to the
BHS.
IP Access Control
You can permit access to the BHS from any IP address (IP Access Filtering Disabled) or limit it
to access from only one, two, or three IP addresses that you specify (IP Access Filtering
Enabled). If you select IP Access Filtering Enabled, then you must populate at least one of the
three Allowed Source IP parameters or have no access permitted from any IP address, including
access and management by Prizm.