User guide

Canopy System User Guide Configuring a BH Timing Slave for the
Destination
pmp-0229 (Mar 2013)
369
SNMP Trap Server DNS Usage
The management DNS domain name may be toggled such that the name of the trap server only
needs to be specified and the DNS domain name is automatically appended to that name. The
default SNMP trap server addresses for all 10 available servers is 0.0.0.0 with the appending of the
DNS domain name disabled.
Trap Address
1 to 10
Specify ten or fewer IP addresses (xxx.xxx.xxx.xxx) to which trap information should be sent.
Trap information informs Prizm or an NMS that something has occurred. For example, trap
information is sent
• after a reboot of the module.
• when Prizm or an NMS attempts to access agent information but either
o supplied an inappropriate community string or SNMP version number.
o is associated with a subnet to which access is disallowed.
Site Information Viewable to Guest Users
Operators can enable or disable site information from appearing when a user is in GUEST account
mode.
Site Name
Specify a string to associate with the physical module. This parameter is written into the sysName
SNMP MIB-II object and can be polled by Prizm or an NMS. The buffer size for this field is 128
characters.
Site Contact
Enter contact information for the module administrator. This parameter is written into the
sysContact SNMP MIB-II object and can be polled by Prizm or an NMS. The buffer size for this
field is 128 characters.
Site Location
Enter information about the physical location of the module. This parameter is written into the
sysLocation SNMP MIB-II object and can be polled by Prizm or an NMS. The buffer size for this
field is 128 characters.
The SNMP tab also provides the following buttons.
Save Changes
When you click this button, any changes that you made on the Configuration page are recorded in
flash memory. However, these changes do not apply until the next reboot of the module.