User guide

Canopy System User Guide Configuring a BH Timing Slave for the
Destination
pmp-0229 (Mar 2013)
363
1. the module reboots.
2. any changes that you saved by a click of the Save Changes button are
implemented.
Radio Tab of the BHS
An example of the Radio tab in a BHS is displayed in Figure 113.
Figure 113: Radio tab of BHS, example
In the Radio tab of the BHS, you may set the following parameters.
Custom Radio Frequency Scan Selection List
Specify the frequency that the BHS should scan to find the BHM. The frequency band of the BHs
affects what channels you select.
IMPORTANT!
In the 2.4-GHz frequency band, the BHS can register to a BHM that transmits on
a frequency 2.5 MHz
higher than the frequency that the BHS receiver locks when
the scan terminates as successful. This establishes a poor-quality link. To
prevent this, select frequencies that are at least 5 MHz apart.
In a 2.4-GHz BHS, this parameter displays all available channels, but has only three recommended
channels selected by default. See 2.4-GHz AP Cluster Recommended Channels on Page 136.