User guide

Canopy System User Guide Configuring a BH Timing Slave for the
Destination
pmp-0229 (Mar 2013)
361
Figure 112: IP tab of BHS, example
In the IP tab of the BHS, you may set the following parameters.
LAN1 Network Interface Configuration, IP Address
Enter the non-routable IP address to associate with the Ethernet connection on this BHS. (The
default IP address from the factory is 169.254.1.1.) If you set and then forget this parameter, then
you must both
1. physically access the module.
2. use an override plug to electronically access the module configuration
parameters at 169.254.1.1. See Overriding Forgotten IP Addresses or
Passwords on AP, SM, or BH on Page 433.
RECOMMENDATION:
Note or print the IP settings from this page. Ensure that you can readily associate
these IP settings both with the module and with the other data that you store
about the module.
LAN1 Network Interface Configuration, Subnet Mask
Enter an appropriate subnet mask for the BHS to communicate on the network. The default subnet
mask is 255.255.0.0. See Allocating Subnets on Page 164.