User guide

Configuring a BH Timing Slave for the
Destination
Configuring for the Destination
358
pmp-0229 (Mar 2013)
Timing Mode
Select Timing Slave. This BH will receive sync from another source. Whenever you toggle this
parameter to Timing Slave from Timing Master, you should also do the following:
1. Make no other changes in this or any other interface page.
2. Save this change of timing mode.
3. Reboot the BH.
RESULT: The set of interface web pages that is unique to a BHS is made available.
NOTE:
In a BHS that cannot be converted to a BHM, this parameter is not present.
Link Speeds
Specify the type of link speed for the Ethernet connection. The default for this parameter is that all
speeds are selected. The recommended setting is a single speed selection for all APs, BHs, and
SMs in the operator network.
Region Code
From the drop-down list, select the region in which the radio is operating.
When the appropriate region is selected in this parameter, the radio automatically implements the
applicable required Dynamic Frequency Selection (DFS) standard. For further information on
DFS, see Radar Signature Detection and Shutdown on Page 127.
The slave radio automatically inherits the DFS type of the master. This behavior ignores the value
of the Region Code parameter in the slave, even when the value is None. Nevertheless, since
future system software releases may read the value in order to configure some other region-
sensitive feature(s), you should always set the value that corresponds to the local region.
Webpage Auto Update
Enter the frequency (in seconds) for the web browser to automatically refresh the web-based
interface. The default setting is 0. The 0 setting causes the web-based interface to never be
automatically refreshed.