Manualshelf

User guide

ManualsBrandsMotorola ManualsOther5440SM - Canopy 5.4 GHz Subscriber Module
351352353354355356357358359360
Canopy System User Guide Configuring a BH Timing Slave for the
Destination
pmp-0229 (Mar 2013)
355
Set to Factory Defaults Upon Default Plug Detection
If Enabled is checked, then an override/default plug functions as a default plug. When the module
is rebooted with the plug inserted, it can be accessed at the IP address 169.254.1.1 and no
password, and all parameter values are reset to defaults. A subscriber, technician, or other person
who gains physical access to the module and uses an override/default plug cannot see or learn the
settings that were previously configured in it. When the module is later rebooted with no plug
inserted, the module uses the new values for any parameters that were changed and the default
values for any that were not.
If Disabled is checked, then an override/default plug functions as an override plug. When the
module is rebooted with the plug inserted, it can be accessed at the IP address 169.254.1.1 and no
password, and all previously configured parameter values remain and are displayed. A subscriber,
technician, or other person who gains physical access to the module and uses an override/default
plug can see and learn the settings. When the module is later rebooted with no plug inserted, the
module uses the new values for any parameters that were changed and the previous values for any
that were not.
See Overriding Forgotten IP Addresses or Passwords on AP, SM, or BH on Page 433.
The Unit Settings tab also contains the following buttons.
Save Changes
When you click this button, any changes that you made on the Configuration page are recorded in
flash memory. However, these changes do not apply until the next reboot of the module.
Reboot
When you click this button
1. the module reboots.
2. any changes that you saved by a click of the Save Changes button are
implemented.
Configuring a BH Timing Slave for the
Destination
If an ADMINISTRATOR-level password has been set in the BHS, you must log into the module
before you can configure its parameters. See Managing Module Access by Passwords on
Page 430.