User guide

Configuring a BH Timing Master for the
Destination
Configuring for the Destination
346
pmp-0229 (Mar 2013)
IP Access Control
You can permit access to the BHM from any IP address (IP Access Filtering Disabled) or limit it
to access from only one, two, or three IP addresses that you specify (IP Access Filtering
Enabled). If you select IP Access Filtering Enabled, then you must populate at least one of the
three Allowed Source IP parameters or have no access permitted from any IP address, including
access and management by Prizm.
Allowed Source IP 1 to 3
If you selected IP Access Filtering Enabled for the IP Access Control parameter, then you must
populate at least one of the three Allowed Source IP parameters or have no access permitted to
the BHM from any IP address. You may populate as many as all three.
If you selected IP Access Filtering Disabled for the IP Access Control parameter, then no entries
in this parameter are read, and access from all IP addresses is permitted.
The Security tab also provides the following buttons.
Save Changes
When you click this button, any changes that you made on the Configuration page are recorded in
flash memory. However, these changes do not apply until the next reboot of the module.
Reboot
When you click this button
1. the module reboots.
2. any changes that you saved by a click of the Save Changes button are
implemented.
VLAN tab of the BHM
An example of the VLAN tab in a BHM is displayed in Figure 107.