User guide

Canopy System User Guide Configuring a BH Timing Master for the
Destination
pmp-0229 (Mar 2013)
333
LAN1 Network Interface Configuration, Gateway IP Address
Enter the appropriate gateway for the BHM to communicate with the network. The default
gateway is 169.254.0.0.
LAN1 Network Interface Configuration, DHCP State
If you select Enabled, the DHCP server automatically assigns the IP configuration (IP address,
subnet mask, and gateway IP address) and the values of those individual parameters (above) are
not used. The setting of this DHCP state parameter is also viewable, but not settable, in the
Network Interface tab of the Home page.
LAN1 Network Interface Configuration, DNS IP Address
Canopy devices allow for configuration of a preferred and alternate DNS server IP address either
automatically or manually. Devices must set DNS server IP address manually when DHCP is
disabled for the management interface of the device. DNS servers may be configured
automatically from the DHCP response when DHCP is enabled for the management interface of
the device. Optionally devices may be configured to set the DNS server IP address manually when
DHCP is enabled for the management interface. The default DNS IP addresses are 0.0.0.0 when
configured manually.
LAN1 Network Interface Configuration, Preferred DNS
Server
The first address used for DNS resolution.
LAN1 Network Interface Configuration, Alternate DNS Server
Upon failure to reach the Preferred DNS server, the Alternate DNS Server is used.
LAN1 Network Interface Configuration, Domain Name
The operator’s management domain name may be configured for DNS. The domain name
configuration can be used for configuration of the servers in the operator’s network. The default
domain name is example.com, and is only used if configured as such.
LAN2 Network Interface Configuration (RF Private Interface),
IP Address
Enter the IP address to be associated with this BHM for over-the-air access.
The IP tab also provides the following buttons.
Save Changes
When you click this button, any changes that you made on the IP Configuration page are recorded
in flash memory. However, these changes do not apply until the next reboot of the module.