User guide

Configuring a BH Timing Master for the
Destination
Configuring for the Destination
332
pmp-0229 (Mar 2013)
Figure 103: IP tab of BHM, example
You may set the following IP Configuration page parameters.
LAN1 Network Interface Configuration, IP Address
Enter the non-routable IP address to be associated with the Ethernet connection on this module.
(The default IP address from the factory is 169.254.1.1.) If you set and then forget this parameter,
then you must both
1. physically access the module.
2. use an override plug to electronically access the module configuration
parameters at 169.254.1.1. See Overriding Forgotten IP Addresses or
Passwords on AP, SM, or BH on Page 433.
RECOMMENDATION:
Note
or print the IP settings from this page. Ensure that you can readily associate
these IP settings both with the module and with the other data that you store
about the module.
LAN1 Network Interface Configuration, Subnet Mask
Enter an appropriate subnet mask for the BHM to communicate on the network. The default
subnet mask is 255.255.0.0. See Allocating Subnets on Page 164.