User guide

Canopy System User Guide Configuring a BH Timing Master for the
Destination
pmp-0229 (Mar 2013)
327
o Allow Learning : No under Active Configuration.
For the case where the Configuration Source parameter in the AP is set to
Authentication
Server
+SM, and Prizm does not send VLAN values, the SM
• uses the configured value in the SM for Dynamic Learning. If the SM is set to factory
defaults, then this value is Enable.
• shows under Active Configuration the result of the configured value in the SM. For example,
if the SM is set to factory defaults, then the VLAN Configuration page shows Allow
Learning : Yes.
This selection (
Authentication Server+SM) is not recommended where Prizm manages the VLAN
feature in SMs.
Configuring a BH Timing Master for the
Destination
NOTE:
The PTP 400 and PTP 600 series bridges (previously known as 30/60 Mbps and
150/300 Mbps Backhauls) are described in their own dedicated user guides. See
Products Not Covered by This User Guide on Page 24.
If an ADMINISTRATOR-level password has been set in the BHM, you must log into the module
before you can configure its parameters. See Managing Module Access by Passwords on
Page 430.
General Tab of the BHM
An example of the General tab in a BHM is displayed in Figure 102.