User guide

Setting the Configuration Source Configuring for the Destination
324
pmp-0229 (Mar 2013)
Save Changes
When you click this button, any changes that you made on all tabs are recorded in flash memory.
However, these changes do not apply until the next reboot of the module.
Undo Unit-Wide Saved Changes
When you click this button, any changes that you made in any tab but did not commit by a reboot
of the module are undone.
Set to Factory Defaults
When you click this button, all configurable parameters on all tabs are reset to the factory
settings.
Reboot
When you click this button
1. the module reboots.
2. any changes that you saved by a click of the Save Changes button are
implemented.
Setting the Configuration Source
The AP includes a Configuration Source parameter, which sets where SMs that register to the
AP are controlled for MIR, VLAN, the high-priority channel, and CIR as follows.
The Configuration Source parameter affects the source of
• all MIR settings:
o Sustained Uplink Data Rate
o Uplink Burst Allocation
o Sustained Downlink Data Rate
o Downlink Burst Allocation
• all SM VLAN settings:
o Dynamic Learning
o Allow Only Tagged Frames
o VLAN Ageing Timeout
o Untagged Ingress VID
o Management VID
o VLAN Membership
• the Hi Priority Channel setting
• all CIR settings
o Low Priority Uplink CIR
o Low Priority Downlink CIR
o Hi Priority Uplink CIR
o Hi Priority Downlink CIR
Most operators whose plans are typical should consult Table 53.