Manualshelf

User guide

ManualsBrandsMotorola ManualsOther5440SM - Canopy 5.4 GHz Subscriber Module
311312313314315316317318319320
Canopy System User Guide Configuring an SM for the Destination
pmp-0229 (Mar 2013)
313
Current VID Member Set, Type
For each VID number in the first column, the entry in this column correlates the way in which the
module became and continues to be a member:
• Permanent—This indicates that the module was assigned the VID number through direct
configuration by the operator.
• Dynamic—This indicates that the module adopted the VID number through enabled dynamic
learning, when a tagged packet from an SM behind it in the network, or from a customer
equipment that is behind the SM in this case, was read.
Current VID Member Set, Age
For each VID number in the first column of the table, the entry in this column reflects whether or
when the VID number will time out:
• for Permanent type—the number will never time out, and this is indicated by the digit 0.
• for Dynamic type—the Age reflects what is configured in the VLAN Aging Timeout
parameter in the Configuration => VLAN tab of the AP or reflects a fewer number of minutes
that represents the difference between what was configured and what has elapsed since the
VID was learned. Each minute, the Age decreases by one until, at zero, the AP deletes the
learned VID, but can it again from packets sent by elements that are beneath it in the network.
IMPORTANT!
Values in this Active Configuration block can differ from attempted values in
configurations:
◦ A VLAN profile administered by the BAM subsystem in Prizm is
capable of overriding any configured VLAN value, if the
Configuration Source parameter in the AP is set to BAM.
◦ The AP can override the value that the SM has configured for
SM Management VID Pass-Through.
The VLAN tab also provides the following buttons.
Save Changes
When you click this button, any changes that you made on this tab are recorded in flash memory.
However, these changes do not apply until the next reboot of the module.
Reboot
When you click this button
1. the module reboots.
2. any changes that you saved by a click of the Save Changes button are
implemented.