User guide

Configuring an SM for the Destination Configuring for the Destination
304
pmp-0229 (Mar 2013)
Low Priority Downlink CIR
See
• Committed Information Rate on Page 85
• Setting the Configuration Source on Page 324.
Hi Priority Channel
See
• High-priority Bandwidth on Page 86
• Setting the Configuration Source on Page 324.
Hi Priority Uplink CIR
See
• High-priority Bandwidth on Page 86
• Committed Information Rate on Page 85
• Setting the Configuration Source on Page 324.
Hi Priority Downlink CIR
See
• High-priority Bandwidth on Page 86
• Committed Information Rate on Page 85
• Setting the Configuration Source on Page 324.
The Quality of Service (QoS) tab also provides the following buttons.
Save Changes
When you click this button, any changes that you made in this tab are recorded in flash memory.
However, these changes do not apply until the next reboot of the module.
Reboot
When you click this button
1. the module reboots.
2. any changes that you saved by a click of the Save Changes button are
implemented.