User guide

Canopy System User Guide Configuring an SM for the Destination
pmp-0229 (Mar 2013)
303
In the Quality of Service (QoS) tab of the SM, you may set the following parameters.
Sustained Uplink Data Rate
Specify the rate that this SM is replenished with credits for transmission. This default imposes no
restriction on the uplink. See
• Maximum Information Rate (MIR) Parameters on Page 83
• Interaction of Burst Allocation and Sustained Data Rate Settings on Page 86
• Setting the Configuration Source on Page 324.
Sustained Downlink Data Rate
Specify the rate at which the AP should be replenished with credits (tokens) for transmission to
this SM. This default imposes no restriction on the uplink. See
• Maximum Information Rate (MIR) Parameters on Page 83
• Interaction of Burst Allocation and Sustained Data Rate Settings on Page 86
• Setting the Configuration Source on Page 324.
Uplink Burst Allocation
Specify the maximum amount of data to allow this SM to transmit before being recharged at the
Sustained Uplink Data Rate with credits to transmit more. See
• Maximum Information Rate (MIR) Parameters on Page 83
• Interaction of Burst Allocation and Sustained Data Rate Settings on Page 86
• Setting the Configuration Source on Page 324.
Downlink Burst Allocation
Specify the maximum amount of data to allow the AP to transmit to this SM before the AP is
replenished at the Sustained Downlink Data Rate with transmission credits. See
• Maximum Information Rate (MIR) Parameters on Page 83
• Interaction of Burst Allocation and Sustained Data Rate Settings on Page 86
• Setting the Configuration Source on Page 324.
Low Priority Uplink CIR
See
• Committed Information Rate on Page 85
• Setting the Configuration Source on Page 324.