User guide

Configuring an SM for the Destination Configuring for the Destination
294
pmp-0229 (Mar 2013)
Figure 90: IP tab of SM with NAT enabled, example
In the IP tab of an SM with NAT enabled, you may set the following parameters.
NAT Network Interface Configuration, IP Address
Assign an IP address for SM management through Ethernet access to the SM. Set only the first
three bytes. The last byte is permanently set to 1. This address becomes the base for the range of
DHCP-assigned addresses.
NAT Network Interface Configuration, Subnet Mask
Assign a subnet mask of 255.255.255.0 or a more restrictive subnet mask. Set only the last byte of
this subnet mask. Each of the first three bytes is permanently set to 255.
The IP tab also contains the following buttons.
Save Changes
When you click this button, any changes that you made on all tabs are recorded in flash memory.
However, these changes do not apply until the next reboot of the module.
Reboot
When you click this button
1. the module reboots.
2. any changes that you saved by a click of the Save Changes button are
implemented.
An example of the IP tab in an SM with NAT enabled is displayed in Figure 90.
Radio Tab of the SM
An example of the Radio tab in the SM is displayed in Figure 91.