User guide

Canopy System User Guide Configuring an SM for the Destination
pmp-0229 (Mar 2013)
285
Save Changes
When you click this button, any changes that you made on all tabs are recorded in flash memory.
However, these changes do not apply until the next reboot of the module.
Reboot
When you click this button
1. the module reboots.
2. any changes that you saved by a click of the Save Changes button are
implemented.
An example of the IP tab in an SM with NAT disabled is displayed in Figure 88.
Figure 88: IP tab of SM with NAT disabled, example
This implementation is illustrated in Figure 48 on Page 159. In the IP tab of an SM with NAT
disabled, you may set the following parameters.
LAN1 Network Interface Configuration, IP Address
Enter the non-routable IP address to associate with the Ethernet connection on this SM. (The
default IP address from the factory is 169.254.1.1.) If you set and then forget this parameter, then
you must both
1. physically access the module.
2. use an override plug to electronically access the module configuration
parameters at 169.254.1.1. See Overriding Forgotten IP Addresses or
Passwords on AP, SM, or BH on Page 433.