User guide

Configuring an SM for the Destination Configuring for the Destination
284
pmp-0229 (Mar 2013)
Remote Configuration Interface, IP Address
This parameter is not configurable when NAT is disabled.
Remote Configuration Interface, Subnet Mask
This parameter is not configurable when NAT is disabled.
Remote Configuration Interface, Gateway IP Address
This parameter is not configurable when NAT is disabled.
Remote Configuration Interface, DNS IP Address
This parameter is not configurable when NAT is disabled
Remote Configuration Interface, Preferred DNS Server
This parameter is not configurable when NAT is disabled
Remote Configuration Interface, Alternate DNS SErver
This parameter is not configurable when NAT is disabled
Remote Configuration Interface, Domain Name
This parameter is not configurable when NAT is disabled
NAT Protocol Parameters, ARP Cache Timeout
If a router upstream has an ARP cache of longer duration (as some use 30 minutes), enter a value
of longer duration than the router ARP cache. The default value of this field is 20 minutes.
NAT Protocol Parameters, TCP Session Garbage Timeout
Where a large network exists behind the SM, you can set this parameter to lower than the default
value of 1440 minutes (24 hours). This action makes additional resources available for greater
traffic than the default value accommodates.
NAT Protocol Parameters, UDP Session Garbage Timeout
You may adjust this parameter in the range of 1 to 1440 minutes, based on network performance.
The default value of this parameter is 4 minutes.
The NAT tab also contains the following buttons.