User guide

Canopy System User Guide Configuring an AP for the Destination
pmp-0229 (Mar 2013)
267
CAUTION!
Do not set this parameter to Enable where both
◦ a BAM release earlier than 2.1 is implemented.
◦ the Configuration Source parameter in the AP is set to BAM.
This combination causes the SMs to become unmanageable, until you gain
direct access with an override plug and remove this combination from the AP
configuration.
QinQ EtherType
This parameter is the outer S-VLAN Ethertype that may be configured to interoperate with other
networks that use a different Ethertype than the default.
Active Configuration
When VLAN is enabled in the AP, the Active Configuration block provides the following details
as read-only information in this tab. In the Cambium fixed wireless broadband IP network, each
device of any type is automatically a permanent member of VID 1. This facilitates deployment of
devices that have VLAN enabled with those that do not.
Port VID
This is the VID that the AP will use for tagging frames of the type specified by Allow Frame
Types.
Management VID
This is the value of the parameter of the same name, configured above.
SM Management VID Pass-Through
This is the value of the parameter of the same name, configured above.
Dynamic Ageing Timeout
This is the value of the VLAN Aging Timeout parameter configured above.
Allow Learning
Yes is displayed if the value of the Dynamic Learning parameter above is Enabled. No is
displayed if the value of Dynamic Learning is Disabled.