User guide

Configuring an AP for the Destination Configuring for the Destination
266
pmp-0229 (Mar 2013)
VLAN
Specify whether VLAN functionality for the AP and all linked SMs should (Enabled) or should
not (Disabled) be allowed. The default value is Disabled.
Always use Local VLAN Config
Enable this option before you reboot this AP as an SM to use it to perform spectrum analysis.
After the spectrum analysis is completed and before you reboot this module as an AP, disable this
option.
Allow Frame Types
Select the type of arriving frames that the AP should tag, using the VID that is stored in the
Untagged Ingress VID parameter. The default value is All Frames.
Dynamic Learning
Specify whether the AP should (Enabled) or should not (Disabled) add the VLAN IDs (VIDs) of
upstream frames to the VID table. (The AP passes frames with VIDs that are stored in the table
both upstream and downstream.) The default value is Enabled.
VLAN Aging Timeout
Specify how long the AP should keep dynamically learned VIDs. The range of values is 5 to 1440
(minutes). The default value is 25 (minutes).
NOTE:
VIDs that you enter for the Management VID and VLAN Membership
parameters do not time out.
Management VID
Enter the VID that the operator wishes to use to communicate with the module manager. The
range of values is 1 to 4095. The default value is 1.
SM Management VID Pass-through
Specify whether to allow the SM (Enable) or the AP (Disable) to control the VLAN settings of
the SM. The default value is Enable.