User guide

Configuring an AP for the Destination Configuring for the Destination
260
pmp-0229 (Mar 2013)
Broadcast Downlink CIR is closely related to the Broadcast Repeat Count parameter, which is
settable in the Radio tab of the Configuration page in the AP: when the Broadcast Repeat Count is
changed, the total of available bandwidth is also changed, since packets are being sent one, two, or
three times, according to the setting in the Broadcast Repeat Count parameter. (See Broadcast
Repeat Count on Page 251.)This relationship is shown in Table 52.
Table 52: Broadcast Downlink CIR achievable per Broadcast Repeat Count
Broadcast
Repeat
Count
Number of times
each packet is sent
Highest Achievable
Value for Broadcast
Downlink CIR
0 1 7000 kbps
1 2 3500 kbps
2 3 2333 kbps
The Quality of Server (QoS) tab also provides the following buttons.
Save Changes
When you click this button, any changes that you made on this tab are recorded in flash memory.
However, these changes do not apply until the next reboot of the module.
Reboot
When you click this button
1. the module reboots.
2. any changes that you saved by a click of the Save Changes button are
implemented.