User guide

Configuring an AP for the Destination Configuring for the Destination
258
pmp-0229 (Mar 2013)
Site Location
Enter information about the physical location of the module. This parameter is written into the
sysLocation SNMP MIB-II object and can be polled by PrizmEMS or an NMS. The buffer size for
this field is 128 characters.
The SNMP tab also provides the following buttons.
Save Changes
When you click this button, any changes that you made on this tab are recorded in flash memory.
However, these changes do not apply until the next reboot of the module.
Reboot
When you click this button
1. the module reboots.
2. any changes that you saved by a click of the Save Changes button are
implemented.
Quality of Service (QoS) Tab of the AP
An example of the Quality of Service (QoS) tab of the AP is displayed in Figure 79.
Figure 79: Quality of Service (QoS) tab of AP, example
In the Quality of Service (QoS) tab, you may set AP bandwidth parameters as follows.