User guide

Canopy System User Guide Configuring a Point-to-Point Link for Test
pmp-0229 (Mar 2013)
231
Ethernet Interface
If an Ethernet link to the module exists, this field indicates the speed and duplex state of the
Ethernet interface to the module.
Regulatory
This field indicates whether the configured Region Code and radio frequency are compliant with
respect to their compatibility. For example, you may configure a 5.4-GHz AP with a Region Code
set to United States and configure a frequency that lies within the weather notch. This is a
compliant combination, the radio properly operates, and its Regulatory field displays Passed. If
later you change its Region Code to Canada, then the combination becomes non-compliant (since
frequencies within the weather notch are disallowed in Canada. In this case, the radio ceases to
transmit, and its Regulatory field displays an error message.
For further information on Region Codes and DFS, see Radar Signature Detection and Shutdown
on Page 127.
DFS
This field indicates the current behavior of the radio with respect to Dynamic Frequency Selection.
Possible messages in this field are
• Normal Transmit
• Radar Detected Stop Transmitting for n minutes, where n counts down from 30 to 1.
• Checking Channel Availability Remaining time n seconds, where n counts down from 60 to 1.
Antenna
The presence of this field depends on whether antenna options are available for the module. This
field indicates the polarity of the antenna in the modules as one of the following:
• Horizontal
• Vertical
• External (Connectorized)
Temperature
This field displays the current operating temperature of the device (range −40°C to +55°C (−40°F to
131°F)).
Timing Slave Status
This field indicates whether this backhaul master is currently in link with a backhaul slave.
GPS Sync Pulse Status
This field indicates the status of synchronization as follows: